Antex electronics TriplePlay Multizone Satellite Audio Receiver Manual de usuario Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 7
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
*PW
Password command
This command will change the current password.
If *
PW,pppp,wwww,wwww
{
cr
} is sent, where pppp
is the old 4 digit password and
wwww
is
the new 4 digit password, the password will be change to
wwww
.
The new password is sent
twice for verification.
Returned
*PW1{
cr
}
New password accepted
*PW0{
cr
}
failed
(old password is incorrect)
*
SLz
Select command
This command is the equivalent of the select button on the front panel.
It can be sent after a
*CD, *CU, *CGD and *CGU command to cause the receiver to direct tune to the last channel
sent by these commands. This command must be sent within 4 seconds of the previous listed
commands or it will be ignored.
*
Zz
Zone select
command
This command changes the currently active zone.
If *
Z1{
cr
} is sent zone 1 will become the currently active zone.
Nothing is returned.
*
PSz
Preset select command
This command selects or stores a preset for the selected zone.
If *
PSz,n
{
cr
} is sent, where n is the preset number 0
9, the channel in the selected zone will be
changed to the stored channel in preset n.
Returned:
*
PSz
,n,ccc,catagory,channel
name,artist
name,song
title{
cr
}
If * PSz
,n,ccc
{
cr
} is sent, the channel number
ccc
will be stored in preset n.
Nothing is returned.
*SS
Signal
Streangth
This command will return *
SS,tt,rr,ss
{
cr
} where
tt
is a two digit terrestrial signal strength 00
-
99,
rr
is a two digit strength satellite 1 and
ss
is a two digit signal strength for satellite 2.
Note:
If you are using firmware v1.01.111 or older, you should only use the commands from above. If you are
using firmware v1.01.112 or newer, you can use all the commands on this document except for
*SS
.
*SV
Signal Value
This command will return *
SV
,n{
cr
} where
n
is
one
a digit
signal strength
received by the
unit,
in the range of
0
to 3
.
0
: No Signal
Page
5
of
7
Antex SRX
-
3 TriplePlay Multizone Satellite Receiver
8/2/2008
http://www.antex.com/support/Web%20Site%20Sirius%20Receiver%20RS232%20control%20spe
...
Vista de pagina 4
1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios